Milan FWD V6-3.0L (2010)
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Carrying out Programmable Module Installation (PMI) will not enable the 911 assist option that is disabled. The RCM and Accessory Protocol
Interface Module (APIM) must be configured correctly to fully support 911 assist functionality.
NOTE: This vehicle is equipped with the SYNC(R) V2 feature which contains the 911 assist option. Refer to the Owners' Literature.
NOTE: Always make sure the correct SRS component is being installed. Parts released for other vehicles may not be compatible even if they appear
physically similar. Check the part number listed in the Master Parts Catalog to make sure the correct component is being installed. If an incorrect SRS
component is installed, DTCs may set.
1. If installing a new RCM, carry out the steps necessary to prepare for Programmable Module Installation (PMI). For additional information, refer to
Information Bus.
2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint
System (SRS) Depowering and Repowering in the General Procedures portion.
3. Remove the 2 RH RCM bolts.
-
Position the carpet back at the RH side of the center tunnel area under the instrument panel and remove the 2 bolts.
4. Disconnect the large RCM connector.
1. Pinch the thumb tab and pivot the Connector Position Assurance (CPA) lever back.
2. Disconnect the RCM connector.
5. Remove the RCM.
1. Disconnect the small RCM connector.
2. Remove the LH bolt.
3. Remove the RCM.
Installation
1. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
Position the RCM.
-
Install the 2 RH RCM bolts.
-
Tighten to 12 Nm (106 lb-in).
-
Position the carpet back at the RH side of the center tunnel area under the instrument panel.
2. Install the RCM.
-
Install the LH RCM bolt.
