Milan FWD V6-3.0L (2010)
3. Connect the small RCM connector.
4. Verify that the CPA lever is positioned back completely (as shown) before connecting the large RCM connector.
5. NOTICE: Placing the large Restraints Control Module (RCM) electrical wiring connector into the RCM on an angle can cause bad
electrical connections and damaged components.
Position the large RCM electrical connector into the RCM.
-
NOTICE: Do not push the connector such that the Connector Position Assurance (CPA) lever pivots and seats. Use light force to
insert the connector into the Restraints Control Module (RCM) before using the CPA lever to lock the connector. Damage to the
connector or component may occur.
With the large RCM electrical connector uniformly aligned to the RCM, push in until a slight resistance is felt.
6. Connect the large RCM connector.
-
Insert the connector into the RCM.
-
Push to lock the CPA lever thumb tab to the RCM.
7. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion.
8. If a new RCM was installed, carry out the appropriate steps necessary to complete PMI. For additional information, refer to Information Bus.
