Milan FWD V6-3.0L (2010)
Fusion and Milan Hybrid
15. Connect the knee air bag module electrical connector.
16. Install the steering column opening trim panel and 2 screws.
All vehicles
17. Install the driver air bag module. For additional information, refer to Driver Air Bag Module See: Air Bag Systems/Air Bag/Service and
Repair/Driver Air Bag Module.
18. Turn the ignition from OFF to ON.
19. Install RCM fuse 32 (10A) in the SJB and close the cover.
20. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable.
21. Prove out the SRS as follows:
Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition ON and monitor the air bag warning indicator with the air bag modules
installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS fault is detected,
the air bag warning indicator will:
- fail to light.
- remain lit continuously.
- flash.
The flashing might not occur until approximately 30 seconds after the ignition has been turned from the OFF to the ON position. This is the time
required to complete testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime will sound in a pattern of 5
sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and repaired.
Clear all RCM and OCSM CMDTCs.
