Milan FWD V6-3.0L (2010)
5. NOTE: This step is to remove approximately one-fourth tank of the fuel from a completely full fuel tank and the majority of any residual fuel in
the fuel tank filler pipe, lowering the fuel level below the Fuel Pump (FP) module mounting flange.
Attach the Fuel Storage Tanker to the fuel drain tube and remove one-fourth (approximately 4 gallons) of fuel from the tank.
3.0L vehicles with more than three-fourths of a tank of fuel
NOTE: The Easy Fuel(TM) (capless) fuel tank filler pipe on 3.0L vehicles have an anti-siphon grate that will not allow a fuel drain tube to penetrate the
fuel tank and requires the following steps to drain the fuel.
6. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
7. NOTE: The supplemental refueling adapter is located in the luggage compartment.
Install the supplemental refueling adapter and a length of semi-rigid fuel drain tube into the Easy Fuel(TM) (capless) fuel tank filler pipe.
8. Attach the Fuel Storage Tanker to the fuel drain tube and remove any residual fuel in the fuel tank filler pipe.
9. NOTE: Index-mark the fuel tank filler pipe hose and the clamp prior to removal for correct installation.
Release the clamp and disconnect the hose from the fuel tank filler pipe.
-
To install, tighten to 4 Nm (35 lb-in).
10. Insert a semi-rigid fuel drain tube into the fuel tank filler pipe hose until it enters the fuel tank.
