Milan FWD V6-3.0L (2010)
All vehicles
11. Remove the 3 screws and the fuel level sensor access cover.
-
To install, tighten to 2 Nm (18 lb-in).
12. NOTE: Clean the fuel level sensor connections, flange surfaces and the immediate surrounding area of any dirt or foreign material.
Disconnect the fuel level sensor electrical connector.
13. NOTE: Place absorbent pads in the general work area in case of fuel spillage.
Release the lock tab, rotate the fuel level sensor counterclockwise approximately one-fourth turn and lift upward.
14. NOTICE: Inspect the mating surfaces of the fuel level sensor flange and the fuel tank O-ring seal contact surfaces. Do not polish or adjust
the O-ring seal contact area of the fuel tank flange or the fuel tank. Install a new fuel level sensor or fuel tank if the O-ring seal contact
area is bent, scratched or corroded.
NOTICE: The fuel level sensor must be handled carefully to avoid damage to the float arm.
NOTE: Carefully remove the fuel level sensor from the fuel tank to avoid fuel spillage inside the vehicle.
Carefully lift and remove the fuel level sensor from the fuel tank.
15. To install, reverse the removal procedure.
-
Make sure the fuel level sensor locking tab is correctly positioned.
