Milan FWD V6-3.0L (2010)
14. NOTICE: Make sure that when installing the manual control lever it is fully seated onto the manual control lever shaft or damage to the
manual control lever shaft will occur and the lever will come loose.
NOTICE: Make sure to hold the manual control lever while tightening the manual control lever nut or damage to the manual control
lever and park components will occur.
Install the manual control lever and the nut.
-
Tighten to 24 Nm (18 lb-ft).
15. Connect the selector lever cable end to the manual control lever with the manual control lever and selector lever in DRIVE. Check selector lever
cable adjustment. For additional information, refer to Automatic Transmission/Transaxle.
16. Install the ACL assembly. For additional information, refer to Fuel Delivery and Air Induction.
17. Fill the transaxle with clean transmission fluid.
18. Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure
that the transmission fluid is at the correct level.
