Milan FWD V6-3.0L (2010)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
3. Remove the bolt and the CKP.
-
To install, tighten to 10 Nm (89 lb-in).
-
Inspect the O-ring seal and install new as necessary.
4. NOTE: Lubricate the CKP O-ring seal with clean engine oil.
To install, reverse the removal procedure.
5. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.