Milan FWD V6-3.0L (2010)
-
Measure the voltage of the battery.
-
Is the voltage less than 16 volts?
Yes
GO to I2.
No
GO to I3.
-------------------------------------------------
I2 TEST BATTERY CONDITION
-
Ignition OFF.
-
Carry out the battery condition test. Refer to Battery. See: Battery/Testing and Inspection/Pinpoint Tests
-
Did the battery pass the condition test?
Yes
GO to I4.
No
DTC U3003:17 was most likely set due to the 12-volt battery being recently jump started or incorrectly charged using a battery charger. INSTALL a new
battery. CLEAR the DTC. REPEAT the self-test. TEST the system for normal operation. If DTC U3003:17 is still present, GO to I3.
-------------------------------------------------
I3 INSPECT VEHICLE ACCESSORIES
-
Ignition OFF.
-
Inspect the vehicle and disable any customer installed accessories.
-
Start the engine.
-
Measure the voltage of the battery.
-
Is the voltage less than 16 volts?
Yes
COMMUNICATE the accessory concern to the customer. CLEAR the DTC. REPEAT the self-test. TEST the system for normal operation.
No
GO to I4.
-------------------------------------------------
I4 CLEAR DTCs AND CARRY OUT SELF-TEST OF THE DC/DC
