Milan FWD V6-3.0L (2010)
31. Using the Front Hub Remover, separate the halfshaft from the wheel hub.
-
Using mechanics wire or equivalent, support the halfshaft.
-
Repeat on the opposite side.
32. Position aside the lower control arms.
33. Lower the subframe from the vehicle.
Installation
All vehicles
1. Partially raise the subframe.
2. Position the halfshafts to the wheel hubs.
3. Position the lower control arms to the subframe.
-
Loosely install new rear lower arm-to-subframe bolts.
4. Raise the subframe and align to the witness marks made during removal.
5. Install the 4 new front subframe nuts.
-
Tighten to 150 Nm (111 lb-ft).
6. Install the 4 front subframe bracket bolts.
-
Tighten to 103 Nm 76 lb-ft).
7. Remove the Powertrain Lift Table.
8. Using the Halfshaft Installer, in the halfshafts Into the wheel hubs.
9. NOTICE: Do not tighten the halfshaft nuts with the vehicle on the ground. The nuts must be tightened to specification before the vehicle
Is lowered onto the wheels. Wheel bearing damage will occur If the wheel bearing Is loaded with the weight of the vehicle applied.
