Milan FWD V6-3.0L (2010)
28. NOTICE: The steering gear/dash seal must be fully seated In the steering valve tower groove before the retaining clips are fully engaged
Into the body. If the steering gear/dash seal Is not seated to the steering gear valve tower groove and the clips are not fully engaged to the
body, water and foreign material may enter the passenger compartment and damage the vehicle Interior.
Install the steering gear/dash seal.
-
To install, apply hand force to the center of the seal, install the steering gear/dash seal onto the steering gear valve tower until fully seated In
the valve tower groove. Install the steering gear/dash seal until the clips are fully engaged Into the body.
29. Position the steering column shaft to the steering gear.
-
Install a new steering column shaft bolt.
-
Tighten to 20 Nm (15 lb-ft).
30. Install the steering column shaft joint cover and nuts.
31. Remove the steering wheel holding device.
