Milan FWD V6-3.0L (2010)
Shift Solenoid D (SSD) are all normally high pressure solenoids. Shift Solenoid E (SSE) is not a VFS, it is an ON/OFF solenoid.
4. If installing a new LPC solenoid, SSB or SSD, note the color of the electrical terminal area of the solenoid. The color will be blue or green and the
solenoid can only be replaced with the same color solenoid. If a new solenoid with that color is not available, install a new solenoid body, refer to
Solenoid Body Assembly See: Automatic Transmission/Transaxle/Valve Body/Service and Repair/6F35/Solenoid Body Assembly.
5. Determine the part number suffix by checking the solenoid service band number etched on the side of the solenoid. The band number is the third
digit on the side of the solenoid and will be a 1, 2, 3, 4 or 5. Use the following table to determine the part number suffix and match the new
solenoid base part number and suffix with the old solenoid. Install the solenoid in the solenoid body.
6. Install the solenoid retaining pin(s).
