Milan FWD V6-3.0L (2010)
8. Clean the main control cover sealing surface and inspect for damage.
9. Apply silicone to the main control sealing surface of the transaxle case.
10. Position the main control cover in place.
11. NOTICE: Inspect the main control cover grommet to make sure that the seal is on the inside of the main control cover. Transmission
fluid leak will occur.
NOTE: Install the stud bolts in the locations noted during disassembly.
Tighten the 8 main control cover bolts and 5 stud bolts.
-
Tighten to 12 Nm (106 lb-in).
12. Position the transmission fluid cooler tube bracket and transmission fluid cooler tube assembly in place and install the 2 nuts.
-
Tighten to 9 Nm (80 lb-in).
