Milan FWD V6-3.0L (2010)
After the transmission fluid has been changed a total of 3 times, check the transmission fluid level for a final time, making sure that the
transmission fluid is at the correct level.
Transmission Fluid Exchange
Transmission Fluid Exchange
NOTICE: Use transmission fluid specific for this transmission. Do not use any supplemental transmission fluid additives or cleaning agents.
The use of these products can cause internal transmission components to fail, which will affect the operation of the transmission.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Use the Heavy-Duty Transmission and Power Steering Fluid X-Changer to change the fluid.
3. Connect the Heavy-Duty Transmission and Power Steering Fluid X-Changer to the transmission fluid cooler tube after the transmission fluid
cooler on the return tube. This will help remove any foreign material trapped in the transmission fluid coolers.
4. Perform the transmission fluid exchange using the Heavy-Duty Transmission and Power Steering Fluid X-Changer. Follow the manufacturer's
instructions included with the machine.
5. Once the transmission fluid exchange is completed, disconnect the Heavy-Duty Transmission and Power Steering Fluid X-Changer. Reconnect any
disconnected transmission fluid cooler tubes.
6. Using the scan tool with the engine running, check and make sure that the transmission is at normal operating temperature 66-77°C (150-170°F).
Check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of
0.24L (0.5 pt) until the correct level is achieved.
