Milan FWD V6-3.0L (2010)
10. Remove the 2 bolts, suction cover and gasket.
11. Remove the 6 main control valve body bolts in the sequence shown.
12. NOTE: Be careful when removing the main control valve body, the manual control lever will fall out of its bore. Also, once all the bolts are
removed, the main control valve body will fall out of the transaxle.
Remove the main control valve body.
Installation
1. NOTICE: When installing the main control valve body, place the wire harness in the open space of the separate plate, being careful not to
pinch the harness. Damage to the harness will occur.
Connect the manual valve link and position the main control valve body in place.
2. Loosely install the 6 main control valve body bolts in the sequence shown.
