Milan FWD V6-3.0L (2010)
3. Install the suction cover gasket, cover and loosely install the 2 bolts.
4. Tighten the 8 bolts to 10 Nm (89 lb-in) in the sequence shown.
5. Lubricate the O-ring with clean automatic transmission fluid and install the TFT sensor.
-
Tighten to 10 Nm (89 lb-in).
6. Install the 2 speed sensor wire connectors on the solenoid clamp.
1. Install the Output Shaft Speed (OSS) sensor wire connector on the solenoid clamp.
2. Install the Turbine Shaft Speed (TSS) sensor wire connector on the solenoid clamp.
7. Connect the wire harness to the solenoids.
1. Install the wire harness into the clamps.
-
Connect the 8 solenoid connectors and the 2 speed sensor connectors.
