Milan FWD V6-3.0L (2010)
12. Install the underbody cover and the screws.
13. Remove the transmission fluid fill plug.
14. Fill the transaxle with approximately 4.7L (5 qt) of clean transmission fluid.
15. Install the transmission fluid fill plug.
-
Tighten to 39 Nm (29 lb-ft).
16. With the transaxle in PARK, the vehicle on a level surface, the engine at idle (680-780 rpm) and foot pressed on the brake, move the selector lever
through each gear and allow engagement of each gear. Place the selector lever back in the PARK position.
17. Wipe the transmission fluid level indicator cap and remove the transmission fluid level indicator.
18. Wipe the transmission fluid level indicator with a clean cloth.
19. NOTE: In order to get an accurate transmission fluid level reading, the vehicle should be on a level surface. Idle the engine to reach the normal
operating temperature. Using the scan tool, verify that the transaxle is at normal operating temperature 60°C-70°C (140°F-158°F), prior to
adjusting the transmission fluid level.
If transmission fluid needs to be added, add transmission fluid in 0.25L (1/2 pt) increments through the transmission fluid fill plug located on the
top of the transaxle near the transmission fluid level indicator. Do not overfill the transmission fluid. Install the transmission fluid level indicator
back in the transmission fluid filler tube until it is fully seated, then remove the transmission fluid level indicator. The transmission fluid level
should be at the upper most mark on the transmission fluid level indicator. Only fill to the upper most mark on the transmission fluid level
indicator. Do not overfill. Damage to the transaxle will occur.
20. NOTE: The correct transmission fluid level at normal operating temperature of 60°C-70°C (140°F-158°F) is between the top 2 marks on the
transmission fluid level indicator.
Fill the transaxle to the correct transmission fluid level.
