Milan FWD V6-3.0L (2010)
13. Connect the transaxle electrical wiring harness retainers to the main control cover stud bolts.
14. Connect the transaxle electrical connector.
15. Install the underbody cover and the screws.
16. Install the ACL assembly. For additional information, refer to Fuel Delivery and Air Induction.
17. Fill the transaxle with clean transmission fluid.
18. Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure
that the transmission fluid is at the correct level.
