Milan FWD V6-3.0L (2010)
Installation
1. Install a new halfshaft seal on the Seal Installer and Handle.
2. Using the Seal Installer and Handle, install the RH halfshaft seal.
3. Install the front RH halfshaft. For additional information, refer to Drive Axles, Bearings and Joints.
4. Fill the transaxle with clean transmission fluid.
5. Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure
that the transmission fluid is at the correct level.
Halfshaft Seal - LH
Halfshaft Seal - LH
