Milan FWD V6-3.0L (2010)
4. Remove the inboard CV joint housing and discard. (Figure 2)
5. Push the boot back and remove all the grease from the boot.
6. Install half of the packet of grease (supplied with kit) into the new CV joint housing. Inject the other half of grease into the boot on the CV tripod
joint.
7. Install the new inboard CV joint housing on the CV tripod joint and new large inboard CV boot clamp.
8. Insert a small, flat-blade screwdriver under the boot seat to allow the air to escape. Slide the tripod joint in as far as it will go, then pull it out 0.787 in
(20 mm). Remove the screwdriver.
9. Using special service tool 205-343 (constant velocity joint boot clamp installer) or equivalent, install the new CV boot clamp. (Figure 3)
2010 Fusion And Milan
1. Replace the LH halfshaft and seal. Refer to WSM, Section 307-01. When the halfshaft seal is removed, visually inspect the transaxle case bushing for
wear.
a. If bushing is visually worn, replace the bushing in the transaxle case. Refer to WSM, Section 307-01.
b. If bushing is not visually worn; clean the area behind the halfshaft seal before installing the new seal.
