Milan FWD V6-3.0L (2010)
16. Install the ACL assembly. For additional information, refer to
Fuel Delivery and Air Induction.
17. Fill the transaxle with clean transmission fluid.
18. Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure
that the transmission fluid is at the correct level.
Turbine Shaft Speed (TSS) Sensor
Turbine Shaft Speed (TSS) Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
