Milan FWD V6-3.0L (2010)
NOTE: Transmission fluid cooler backflushing will be carried out using the Turbo-Tank Heated Cooler Line Flusher or equivalent. Follow the
manufacturer's instructions included with the machine. Test the equipment to make sure that a vigorous fluid flow is present before proceeding.
1. Check and top off fluid level of the Turbo-Tank Heated Cooler Line Flusher or equivalent tank with transmission fluid.
2. Allow the fluid in the Turbo-Tank Heated Cooler Line Flusher or equivalent 15-30 minutes to heat up to 60°C (140°F) before using.
3. Install the line adapters into the transmission cooler lines.
4. NOTE: The TOP transaxle cooler tube on the transaxle is the pressure line.
Attach the Turbo-Tank Heated Cooler Line Flusher or equivalent red line to the transmission fluid cooler pressure line quick disconnect fitting.
5. Attach the Turbo-Tank Heated Cooler Line Flusher or equivalent blue line to the transmission fluid cooler return line quick disconnect fitting.
6. Follow the equipment instructions to purge the cooler lines and cooler prior to starting the flushing procedure.
7. Allow the cooling system to backflush for 10-15 minutes, then flush the cooler in a normal flow direction for an additional 10-15 minutes.
8. Clean the transaxle mounted fluid cooler tubes by hand.