Milan FWD V6-3.0L (2010)
3. Remove the 4 screws and position the LH fender splash shield aside.
4. Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.
5. Remove the lower 2 transaxle insulator-to-frame bolts.
6. Remove the exhaust Y-pipe. For additional information, refer to Exhaust System &/or Catalytic Converter.
7. NOTICE: The Oil Pan Holding Fixture must be carefully aligned to the mounting bosses on the oil pan. Failure to follow these
instructions may result in damage to the oil pan.
Position a floor jack and the Oil Pan Holding Fixture under the oil pan.
8. Remove the Air Cleaner (ACL). For additional information, refer to Engine.
9. Remove the transaxle support insulator through bolt.
