Milan FWD V6-3.0L (2010)
Drive/Propeller Shaft: Removal and Replacement
Driveshaft
Removal and Installation
NOTE: Index-mark both the driveshaft flanges.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
NOTICE: Make sure to adequately support the exhaust flex pipe or damage may occur.
2. Remove and discard the 2 nuts and separate the exhaust system at the flex pipe.
-
Install new nuts and tighten to 40 Nm (30 lb-ft).
3. Support the exhaust system and disconnect the 2 front exhaust hangers from the exhaust system.
4. Carefully lower the exhaust system to allow clearance for removal of the driveshaft.