Milan FWD V6-3.0L (2010)
9. Remove the clutch hydraulic tube from the plastic retainer.
10. NOTE: If one or both of the mount studs are removed or come out, do not reinstall the old stud(s). Install a new stud(s). Make sure the studs are
properly seated in the case, even if they were not replaced.
Remove the remaining 2 transaxle rear support insulator-to-frame bolts, the 2 transaxle rear support insulator nuts and the transaxle rear support
insulator-to-transaxle bolt.
11. Remove the transaxle rear support insulator.
Installation
1. Install the transaxle rear support insulator.
2. NOTE: If one or both of the mount studs are removed or come out, do not reinstall the old stud(s). Install a new stud(s). Make sure the studs are
properly seated in the case, even if they were not replaced.
Install the 2 upper transaxle rear support insulator-to-frame bolts.
-
Tighten to 63 Nm (46 lb-ft).
3. Install the 2 transaxle rear support insulator nuts and the transaxle rear support insulator bolt.
-
Tighten to 80 Nm (59 lb-ft).
4. Install the clutch hydraulic tube into the plastic retainer.
5. Install the clutch hydraulic tube spring clip. Push upward on the clutch tube to attach it to the bracket.
6. Remove the Engine Support Bar.
