Milan FWD V6-3.0L (2010)
1. Verify that the manual lever position markings are aligned. Markings should indicate that the manual lever is in the OVERDRIVE position.
2. Install the TCM.
-
Tighten to 24 Nm (18 lb-ft).
3. Install the manual control lever.
4. Install the manual control lever nut.
-
Tighten to 12 Nm (106 lb-in).
5. Connect the TCM electrical connector.
6. NOTICE: Support the underside of the manual control lever when installing the selector lever cable or damage to the manual control
lever or shaft may occur.
Connect the selector lever cable end.
