Milan FWD V6-3.0L (2010)
2. Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.
3. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.
4. Remove the bolt and the TSS sensor.
Installation
1. Install the TSS sensor and the bolt.
-
Tighten to 10 Nm (89 lb-in).
2. Connect the TSS sensor electrical connector.
3. Install the LH front structure-to-subframe splash shield and the 6 pin-type retainers.
