Milan FWD V6-3.0L (2010)
3. Remove the interior mirror. For additional information, refer to Mirrors.
4. If equipped, remove the rain sensor. For additional information, refer to Wiper and Washer Systems.
5. Partially lower the front portion of the headliner near the windshield header and block with suitable material. For additional information, refer to
Headliner.
6. Remove the cowl panel grille.
7. Before cutting the urethane adhesive, remove dirt and other foreign material from the windshield pinchweld area.
-
Use a clean shop towel or oil-free, compressed air.
8. NOTE: Refer to manufacturer's instructions before using the Deluxe Windshield Removal Tool.
Lubricate the urethane adhesive with water to aid the Deluxe Windshield Removal Tool when cutting.
9. WARNING: Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
WARNING: Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this
instruction may result in serious personal injury.
NOTICE: To avoid rust formation, use extreme care not to scratch the paint or primer or otherwise damage the pinchweld during glass
removal.
NOTE: Insert the blade into the Deluxe Windshield Removal Tool so that the flat side is against the glass. This will leave the entire urethane
adhesive bead on the pinchweld and allow a dry fit of the replacement windshield glass.
NOTE: Support the windshield glass to prevent the glass from dropping while cutting the urethane adhesive.
Insert the Deluxe Windshield Removal Tool at the upper center of the windshield glass and work toward the bottom corners.
10. Using The Pumper, distance the windshield glass from the body.
11. Insert the Deluxe Windshield Removal Tool into the bottom of the urethane adhesive and cut from corner to corner.
12. Carefully remove the windshield glass from the vehicle and place on a stable work surface.
Installation
1. Dry-fit the windshield glass on the existing urethane adhesive bead on the pinch weld.
-
Position the windshield glass on the pinch weld.
-
Center the glass in the opening.
-
Adjust the windshield glass stop blocks (if equipped) as needed for best fit.
-
Make alignment marks with tape or non-staining grease pencil (preferably at the windshield glass stop blocks) on the windshield glass and the
body.
