Montego AWD V6-3.0L VIN 1 (2005)
2.
Open the rear door and remove the belt moulding screw. See Figure 8.
3.
CAUTION: Use care not to bend the moulding during removal. The fastener at the rear end of the moulding will not reattach to the clip on the
door if the moulding is bent. Adjust (straighten) the moulding if necessary.
Remove the belt moulding by lifting the back end up first and then working the moulding out of the channel.
4.
CAUTION: The surfaces the tape is being affixed to must be clean and dry or the tape will not properly adhere. It will be pushed out of position
when the belt moulding is reinstalled and not provide the water protection it is designed for. Make certain the surface where the tape will be
affixed is clean of all contaminants (dirt, dust, grime, tape adhesive residue).
Using a clean rag, wipe the door clean around the rear of the channel.