Montego AWD V6-3.0L VIN 1 (2005)
Front Door Window Motor: Service and Repair
Door Window Regulator Motor
DOOR WINDOW REGULATOR MOTOR
Removal and Installation
NOTE:
-
If installing a new LH front window motor, it must be initialized.
-
The LH front window motor must be de-initialized, then initialized whenever the LH front window motor is removed from the window regulator
drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed, or for any operation in which grease
or lubricants are applied to the window regulator or glass run.
1. Remove the door trim panel and water shield.
2. Disconnect the window motor electrical connector.
3. Secure the glass in position with tape.
4. Remove the 3 window motor screws.
-
To install, tighten to 7 Nm (62 lb-in).
5. Remove the window motor.
6. To install, reverse the removal procedure.
-
If installing a new LH front window motor, it must be initialized. If installing the original LH front window motor, it must be de-initialized,
then initialized.
