Montego AWD V6-3.0L VIN 1 (2005)
8. Remove the interior door handle bolt, and position the door handle aside.
-
To install, tighten to 8 Nm (71 lb-in).
9. NOTE: If the window regulator motor is inoperative, remove it.
Lower the window until the glass clamp bolts can be accessed through the rear access hole and front door speaker opening.
10. Loosen the B-pillar front door window glass clamp bolt.
-
To install, tighten to 8 Nm (71 lb-in).
11. Loosen the A-pillar front door window glass clamp bolt.
-
To install, tighten to 8 Nm (71 lb-in).
12. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
