Montego AWD V6-3.0L VIN 1 (2005)
13. Connect the ECU electrical connector.
14. WARNING: Do not separate components.
CAUTION:
-
Inspect the occupant classification sensor bladder, seat cushion frame and support assembly for any foreign objects before installing
the occupant classification sensor assembly to the seat cushion frame. If any foreign objects are found, remove them. Failure to do so
may result in personal injury in the event of an air bag deployment.
-
Failure to route the seat occupant sensor components through the correct seat cushion support opening can cause component failure.
-
While positioning the seat cushion frame and occupant classification sensor assembly, be careful not to damage any of the
components. Failure to do so can result in component failure.
NOTE: If the original equipment occupant classification sensor (OCS) is not being installed, install a service kit OCS using all parts in the kit.
Position the OCS bladder to the cushion frame.
-
Feed the pressure sensor and hose through the center opening in the cushion frame wires.
15. Install the OCS bladder pin-type retainers.
All seats
16. NOTE: Make sure the pressure sensor is correctly installed and retained to the seat track bracket and the pressure sensor hose is not kinked
during installation.
Install the seat track.
17. Install the front seat backrest.
18. Install the seat.
