Montego AWD V6-30L VIN 1 (2005) Electronic Brake Control Module Locations
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
CAUTION: Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
NOTE: When installing a new ABS module, it must be configured (using vehicle as built data) and calibrated. Follow the diagnostic tool directions
for the calibration procedures. For module configuration, refer to Information Bus.
1. Remove the hydraulic control unit (HCU).
2. Remove the 4 screws and the ABS module.
^
To install, tighten to 3 Nm (27 inch lbs.).
3. To install, reverse the removal procedure.
