Montego AWD V6-3.0L VIN 1 (2005)
Exhaust Manifold: Service and Repair
Exhaust Manifold
RH
Exhaust Manifold - RH
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the RH catalytic converter.
3. Disconnect the HO2S electrical connector.
4. Remove the 3 bolts and the RH exhaust manifold heat shield
^
To install, tighten to 11 Nm (8 ft. lbs.).
5. Disconnect the EGR system module tube from the exhaust manifold.
^
To install, tighten to 40 Nm (30 ft. lbs.).
6. Remove the 6 nuts and the RH exhaust manifold.
^
To install, tighten to 20 Nm (15 ft. lbs.).
