Montego AWD V6-3.0L VIN 1 (2005)
Part 2
Exploded View
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 transaxle roll restrictor brace bolts.
-
To install, clean the bolts using a wire brush, apply new threadlocker to the threads and tighten to 55 Nm (41 lb-ft).
3. Remove the bolt and the transaxle roll restrictor brace.
-
To install, clean the bolts using a wire brush, apply new threadlocker to the threads and tighten to 48 Nm (35 lb-ft).
4. Disconnect the EGR system module-to-EGR system module tube fitting.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Disconnect the EGR system module tube-to-RH exhaust manifold fitting and remove the tube.
-
To install, tighten to 40 Nm (30 lb-ft).
6. To install, reverse the removal procedure.