Montego AWD V6-3.0L VIN 1 (2005)
5. Remove the fluid cooler tube bracket from the transaxle. Remove the fluid cooler tubes.
^
To install, tighten to 10 Nm (89 inch lbs.).
6. Remove the fluid fill plug.
^
To install, tighten to 35 Nm (26 ft. lbs.).
CVT fluid level indicator without crosshatch marks
7. To install, reverse the removal procedure.
1
The fluid level should be at the upper most mark on the fluid level indicator.
^
Fill the transaxle with Motorcraft Continuously Variable Chain Type Transmission Fluid XT-7-QCFT meeting Ford specification
WSS-M2C933-A to the specified level. Fluid should be at the upper most level with fluid temperature at 43°C - 47°C (109°F - 117°F).
^
Prior to adding any transmission fluid, make sure that the vehicle is on a level surface.
^
Check the fluid level to determine how much fluid will need to be added.
^
Using a diagnostic tool, monitor the fluid temperature. Make sure that the fluid temperature is within specification.
CVT fluid level indicator with crosshatch marks
8. To install, reverse the removal procedure.
1
The fluid level should be within the crosshatched marks on the indicator.
^
Fill the transaxle with Motorcraft Continuously Variable Chain Type Transmission Fluid XT-7-QCFT meeting Ford specification
WSS-M2C933-A to the specified level. Fluid should be at the upper most level with fluid temperature at 88°C - 92°C (190°F - 198°F).
^
Prior to adding any transmission fluid, make sure that the vehicle is on a level surface.
^
Check the fluid level to determine how much fluid will need to be added.
^
Using a diagnostic tool, monitor the fluid temperature. Make sure that the fluid temperature is within specification.