Montego AWD V6-3.0L VIN 1 (2005)
13. CAUTION: Do not touch the electrical connector pins. Electrostatic charge may occur and will cause damage to the mechatronic unit.
Remove the mechatronic unit from the transaxle.
14. NOTE: Note the location and size of the 5 feed tubes.
Remove all of the feed tubes.
1
Remove the clutch (manual valve) supply feed tube.
2
Remove the primary pressure feed tube.
3
Remove the secondary pressure feed tube.
4
Remove the main (pump) pressure feed tube (smaller tube).
5
Remove and discard the torque converter clutch pressure feed tube.
15. Remove and discard all of the seals on the feed tubes
1
Remove and discard the inside and outside O-ring seals from the clutch (manual valve) supply feed tube.
2
Remove and discard the O-ring seals from the primary pressure feed tube.
3
Remove and discard the O-ring seals from the secondary pressure feed tube.
4
Remove and discard the O-ring seals from the main (pump) pressure feed tube (smaller tube).
5
Discard the torque converter clutch pressure feed tube.
Installation
