Montego AWD V6-3.0L VIN 1 (2005)
6. Remove the 3 door latch screws.
7. Remove the access hole cover.
8. NOTE: If the door window regulator motor is inoperative, remove it.
Lower the window until the glass clamp bolt is accessible through the access hole plug, then loosen the glass clamp bolt.
-
To install, tighten to 12 Nm (9 lb-ft).
9. Tape the window glass in position.
10. Disconnect the 5 wiring harness retainers and the wiring harness grommet.