Monterey V6-4.2L VIN 2 (2004)
1. Slide the control module off the drive assembly actuator.
INSTALLATION
1. To install, reverse the removal procedure.
Item 1: Screw Installation Note
1. CAUTION: Do not operate the PSD drive assembly actuator with the cables disconnected or damage to the drive assembly actuator may
occur.
NOTE: Verify that the cable does not rub against the sheet metal.
Make sure the cable pulley is fully through the opening.
2. NOTE: Make sure the safety belt is routed on top of the cable conduit.
The cable eyelet clip cannot be reused. Always install a new clip.
3. Initialize both power sliding doors.
