mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Interior - Glove Box Latch Replacement|Page 8447 > < Air Bag Disarming and Arming|Page 8441
Page 1
background image

Glove Compartment Lock: Technical Service Bulletins
Interior - Glove Box Latch Replacement

TSB 05-2-1

02/07/05

GLOVE BOX LATCH REPLACEMENT

FORD:
2004-2005 Freestar

MERCURY:
2004-2005 Monterey

ISSUE
If the glove box latch should require service on a 2004-2005 Freestar/Monterey vehicle, a new service part has now been released.

ACTION
Replace only the glove box latch. The latch can now be serviced separately, it is no longer necessary to replace the entire glove box assembly. Refer to
the following Service Procedure.

SERVICE PROCEDURE

1.

Open the glove box to the maximum position by depressing the two (2) side bumpers.

2.

Remove the three (3) screws near the glove box hinge and remove the entire glove box assembly from the instrument panel.

3.

Remove the four (4) Phillips head screws "A" that retain the inner glove box bin to the outer door (Figure 1).

4.

Disengage the two (2) snaps "B" at the bottom of the bin, these also retain the inner bin to outer door.

5.

Remove the three (3) Phillips head screws "C" that hold the latch assembly to the outer door.

6.

Replace the latch and reverse the above procedure to reassemble.

Parts Block

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage

OPERATION

DESCRIPTION

TIME

050201A

2004-2005

0.3 Hr.

Interior - Glove Box Latch Replacement|Page 8447 > < Air Bag Disarming and Arming|Page 8441