mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Condenser to Evaporator Line|Page 7115 > < Main Climate Control|Page 7112
Page 1
background image

Hose/Line HVAC: Service and Repair
Condenser to Evaporator Line

CONDENSER TO EVAPORATOR LINE

REMOVAL

CAUTION:  Refrigerant compressor oil (mineral oil) F73Z-19577-AA (Motorcraft YN-9-A) should be used to lubricate R-134a refrigerant
system O-ring seals only and should not be added to the R-134a refrigerant system as an A/C compressor lubricant. PAG refrigerant
compressor oil F7AZ-19D589-DA (Motorcraft YN-12-C) or equivalent meeting Ford specification WSH-M1C231-B only should be used as an
A/C compressor lubricant.

NOTE:

-

Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
system contamination from a failed A/C compressor or damage to the suction accumulator.

-

New O-ring seals, lubricated in clean mineral oil, must be installed before reconnecting any A/C fitting that has been disconnected.

1. Position the vehicle on a hoist with the gear selector in NEUTRAL.
2. Recover the refrigerant.
3. Remove the wiper motor and pivot assembly.

Condenser to Evaporator Line|Page 7115 > < Main Climate Control|Page 7112