Monterey V6-4.2L VIN 2 (2004)
Variable Induction Control Actuator: Service and Repair
INTAKE MANIFOLD RUNNER CONTROL (IMRC) ACTUATOR
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the parts in the order indicated in the illustration and table.
INSTALLATION
1. To install, reverse the removal procedure.
Item 3: IMRC Actuator Rods Installation Note
1. New plastic actuator rod retainers must be installed any time the IMRC rods are disconnected.
Item 5: IMRC Actuator Installation Note
1. Before installing the IMRC actuator, be sure to rotate the driver motor plate until the levers make contact with the set screws, then rotate the motor
until the motor bracket bolt holes are aligned with the holes in the lower intake manifold.