Monterey V6-4.2L VIN 2 (2004)
11. Apply Motorcraft(R) Ultra Silicone Sealant around all four sides of the gray header where it meets the PCM sheet metal. (Figure 9)
NOTE
ALLOW 1 HOUR FOR SEALANT TO DRY PRIOR TO INSTALLING PCM.
12. Install the PCM in the vehicle. Refer to WSM, Section 303-14.
NOTE
ONLY 2006-2007 MODEL YEAR FREESTAR AND MONTEREY VEHICLES NEED TO HAVE THE PCM REPROGRAMMED. FOR THESE
VEHICLES ONLY, PROCEED TO STEP 13.
13. Reprogram the powertrain control module (PCM) to the latest calibration using IDS release 49.9 and higher or 50.1 and higher. This new
calibration is not included in the VCM 2007.7 DVD. Calibration files may also be obtained at the website.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
100303A
2004-2005 Freestar,
0.9 Hr.
Monterey: Check DTCs,
Inspect PCM For Water
Intrusion, And Modify
Existing PCM Following
Service Procedure (Do Not
Use With Any Other Labor
Operations)