Monterey V6-4.2L VIN 2 (2004)
11.
Place two (2) of the cut pieces of the PVC sofi foam adhesive stripes on the metal body surface over the transaxle area. The two ends need to
touch, do not allow any gap between the two ends. (Figure 8)
12.
Place the other two cut pieces of the PVC soft foam adhesive stripes on the metal body surface over the PCM area. The two ends need to touch, do
not allow any gap between the two ends. (Figure 9)
13.
Check that the three (3) rubber plugs and five (5) gray plastic clips are fully seated. Add Clear Silicone Rubber around the three (3) rubber plugs
and the five (5) gray plastic clips. (Figure 10)
