mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Air Bag Control Module|Removal and Installation|Page 1919 > < Air Bag Control Module|Removal and Installation
Page 2
background image

The front impact severity sensor is located under the hood latch bracket.

The first row side impact sensors (if equipped) are located under the seat, beneath the carpet.

The second row side impact sensors (if equipped) are located at or near the base of the C-pillar.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

2. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the supplemental

restraint system (SRS) deactivation/reactivation procedure. Refer to Air Bag(s) Arming and Disarming.

Deactivate the supplemental restraint system (SRS). Refer to Air Bag(s) Arming and Disarming.

3. WARNING:  The tightening torque of the air bag restraints control module (RCM) retaining bolts is critical for correct system

operation.

NOTE:  Make sure the battery negative cable is still disconnected before continuing with the installation portion of this procedure.

Remove the parts in the order indicated in the illustration and table.

Item 2: Utility Compartment Removal Note

Air Bag Control Module|Removal and Installation|Page 1919 > < Air Bag Control Module|Removal and Installation