mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Impact Sensor|Removal and Installation|Page 7434 > < Impact Sensor|Removal and Installation|Page 7432
Page 8
background image

(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the sensor
or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.

-

The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could result in
injury and possible violation of vehicle safety standards.

NOTE:

-

The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

-

Vehicles equipped with second row bucket seats shown, vehicles equipped with a second row bench seat are similar.

-

Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.

1. WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing

or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors or RCM, such as doors, instrument panel, console, door latches, strikers, seats
and hood latches.

The front impact severity sensor is located under the hood latch bracket.

The first row side impact sensors (if equipped) are located under the seat, beneath the carpet.

The second row side impact sensors (if equipped) are located at or near the base of the C-pillar. To deplete the backup power supply
energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary batteries and power supplies (if
equipped).

Disconnect the battery ground cable and wait at least one minute.

2. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the supplemental

restraint system (SRS) deactivation/reactivation procedure. Refer to Air Bag(s) Arming and Disarming.

Deactivate the supplemental restraint system (SRS). Refer to Air Bag(s) Arming and Disarming.

Impact Sensor|Removal and Installation|Page 7434 > < Impact Sensor|Removal and Installation|Page 7432