Monterey V6-4.2L VIN 2 (2004)
1. CAUTION:
-
Use care when separating the seat cushion trim cover from the hook and loop strip. The hook and loop strip can be torn from the seat
cushion foam.
-
It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed, a seat side
shield removed, or an OCS service kit is installed. A scan tool is used to trigger the active command to carry out rezeroing of the OCS
system.
If installing an OCS service kit or installing a new seat cushion trim cover, remove the hog rings and separate the trim cover from the foam pad.
-
After removing the hog rings, reach a hand between the trim cover and foam pad and carefully separate the hook and loop strips.
Item 22: Pressure Sensor Removal Note
1. Using a suitable tool, pry the bracket tab, releasing the pressure sensor. Separate the pressure sensor from the seat cushion pan and disconnect the
electrical connector.
Item 24: Occupant Classification Sensor (OCS) Removal Note
1. Feed the OCS hose and pressure sensor through the seat cushion pan opening and remove as an assembly with the bladder.
INSTALLATION
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions and notes at the beginning of the removal
procedure.
NOTE: If installing an OCS service kit, refer to Occupant Classification Sensor - Service Kit.