Monterey V6-4.2L VIN 2 (2004)
Part 3 Of 3
2. Remove the parts in the order indicated in the following illustration and table.
Item 3: Shock Absorber and Spring Assembly Removal Note
1. CAUTION: Do not allow the axle shaft to move outboard. Over-extension of the tripod CV joint can result in separation of internal parts, causing
failure of the axle shaft.
Push down on the front wheel knuckle until the strut and spring assembly is free of the front wheel knuckle. Support the front wheel knuckle to
prevent the front axle shaft from moving outboard.
2. For additional information on the disassembly and assembly of the shock absorber and spring assembly, refer to Shock Absorber and Spring
Assembly.
Item 3: Shock Absorber and Spring Assembly Installation Note
1. Check the front end alignment and adjust as necessary.
