Monterey V6-4.2L VIN 2 (2004)
or repair surface as necessary.
5. Use a wool applicator to apply urethane metal primer to any exposed metal on the pinch weld. Allow 6 to 10 to dry.
6. If reinstalling the original liftgate window glass, remove any excess urethane adhesive.
7. CAUTION: Wipe off the urethane glass prep immediately after each application because it flash dries. Apply deliberate strokes, making
sure not to overlap the applied area.
If installing a new liftgate window glass, apply urethane glass prep twice around the glass surface to be prepped.
8. If installing a new liftgate window glass, apply urethane glass prep to the same area that was prepped in the previous step. Allow 5 minutes to 10
minutes to dry.
9. If equipped, install Norton Foam Sealant 565 Black Foam Tape to the pinch weld area.
10. Cut the urethane adhesive applicator tip to specification.
11. Apply a bead of urethane adhesive to the liftgate door glass on the primed area.
12. CAUTION: Open the windows to prevent the rear window glass from being pushed out by air pressure if a door is closed.
Install the liftgate window glass.
-
After the glass is set, check for water leaks and add urethane adhesive where needed.
13. Install the rear wiper motor.
