Mountaineer V8-302 5.0L VIN P EFI (1998)
Brake Switch (Cruise Control): Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Disconnect the deactivator switch electrical connector.
3. Remove the deactivator switch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE:
^
When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy.
The vehicle may need to be driven 16 km (10 miles) or more to relearn its strategy.
^
After the deactivator switch is installed, it is necessary to bleed the brake system.
