Mountaineer V8-302 5.0L VIN P EFI (1998)
Lamp Out Module: Service and Repair
REMOVAL
1. Position the message center aside.
^
Grasp the front of the console, lift upward and position the message center aside.
2. Remove the rear floor console tray.
^
Grasp the console tray, lift upward and disconnect the two electrical connectors.
3. Remove the lamp outage module.
^
Pull the lamp outage module out, remove the screws and remove the module.
NOTE: The lamp outage module is located under the plastic console reinforcement.
4. Disconnect the electrical connector.
INSTALLATION
1. To install, reverse the removal procedure.